15kg 10kg Smart Robot Servo Be Controlled By Arduino Smart Control
SCServo can work at servo mode and wheel mode.
The servo mode can be used to multi-joints robot since the robots
can be controlled with specific angles. (The factory default
setting is servo mode)
The wheel mode can be used to wheel-type operation robots since
motors of the robots spin infinitely. (If wheel mode is available
you need to program the value of position limitation the both are
If you want to reprogram servo, you need to download the PC
software (SCServo_Debug), and to connect SCPC-2(Serial Control
Programming Card) between servo and PC.
Gear Type(Ratio): Metal(275:1)
Bus Interface: TTL Level Multi Drop
Position Sensor(Resolution): Potentiometer (215°/1024)
Operating Angle: 200°(Servo Mode)
Control System: Bus Packet Communication
Protocol Type Half duplex Asynchronous Serial Communication
ID: 254 ID (0~253)
Communication Speed: 38400bps ~ 1 Mbps
Feedback Position, Temperature, Load, Speed, Input Voltage
Motor Type: Carbon
Bearing Type: 2BB
Operating Voltage: 6V~8.4V
Stall Torque(Kg.cm): 15(6V)
Stall Current(A) : 1.5A(7.4)
Operating Speed(RPM): 55(6V) 65(7.4V) 73(8.4V)
Connector(Wire Length): 3P&5264 (15cm)
Stall torque is the maximum instantaneous and static torque
Stable motions are possible with robots designed for loads with 1/5
or less of the stall torque
Are you interested in the new servo? Come on !email me or call me.
We will give you the best price,you will happy with the servo.
If you have any enquiry, please feel free to contact me, I am glad
to help you.